1. Vol Copy
volcopy is a NetApp ONTAP command that copies all data, including snapshots, from one volume to another.1.1 Prerequisite
- The source and destination volumes must either both flexible volumes or both traditional volumes.
- The source volume must be online and the destination volume must be offline/restricted.
- If data is copied between two filers, each filer must be defined as a trusted host of the other filer.That is, In the /etc/hosts file we need to give partner filer name and IP-address. if we did't mention properly it will display this error "Permission denied"
- The usable disk space of the destination volume must be greater than or equal to the usable disk space of the source volume.
1.2 How to use the volcopy command
Make sure that the above mentioned pre-requisites are completed.
Syntax:
vol copy start [ -S | -s snapshot ] source destination
If the -S flag is used, the command copies all snapshots in the source volume to the destination volume.
To specify a particular snapshot to copy, use the -s flag followed by the name of the snapshot.
If neither the -S nor -s flag is used in the command, the filer automatically creates a distinctively-named snapshot at the time the vol copy start command is executed and copies only that snapshot to the destination volume.
The source and destination volumes must either both be traditional volumes or both be flexible volumes.
The vol copy command will abort if an attempt is made to copy between different volume types.
The source and destination volumes can be on the same filer or on different filers. If the source or destination volume is on a filer other than the one on which the vol copy start command was entered, specify the volume name in the filer_name:volume_name format.
Each volcopy start command generates two volume copy operations: one for reading data from the source volume and one for writing data to the destination volume. Each filer supports up to four simultaneous volume copy operations.
Example:
vol copy start [ -S | -s snapshot ] source destination
How to monitor the status of vol copy operation
Syntax:
vol copy status [operation_number]
Displays the progress of one or all active volume copy operations.
The operations are numbered from 0 through 3.If no operation_number is specified, then status for all active vol copy operations is provided.
1.3 Controlling the speed of Volcopy
Syntax:vol copy throttle [ operation_number ] value
This command controls the performance of the volume copy operation. The value ranges from 10 (full speed) to 1 (one-tenth of full speed).The default value is maintained in the filer's vol.copy.throttle option and is set 10 (full speed) at the factory.The performance value can be applied to an operation specified by the operation_number parameter.
If an operation number is not specified, the command applies to all active volume copy operations.
Please write your valuable comments, about my blogspot.
